WireLog Plus

Description
Features
Sweep Chart

The WireLog Plus Program is used with the WireTrak Sensor and provides a simple MODBUS™ terminal to program and download data from multiple WireTrak™ Sensors. The program uses the MODBUS™ RTU protocol to establish communication with multiple WireTrak devices. The interface to the Sensor is via a RS-485 duplex network.

The WireTrak sensor is a lightweight; compact sensor unit designed for monitoring and telemonitoring service purposes in a welding environment. The WireTrak Sensor includes an embedded micro-controller to provide the necessary data acquisition, signal processing and communications firmware to allow remote logging of the following basic welding parameters.


	Actual Wire Feed Speed

	Arc Time based on wire feed motion

	Arc Time based on wire feed motion

	Totalized Wire Feed Speed and Arc Time

	Volume deposited for last weld

	Totalized volume deposited based on average wire speed and time

Sweep Chart

When the Plot function is enabled the Program will generate a sweep chart for the data collected. The chart X-axis will display the Arc time (in Seconds) when the data was read and the Y-axis will display the associated data values. As time progress new data is appended to the right most position on the graph and old data is pushed to the left. The Y-axis scale is based on the scale values set in the Tool Box Config system tab.

Product Specifications

System Requirements

Required Processor	150mhz Pentium™ or higher microprocessor
Required Operating System	Windows® XP Service Pack 2 or later platforms
Required Memory	24 MB minimum
Required Hard Drive Space	25 MB of available hard drive space
Required Display	Minimum SVGA graphics, XVGA recommended
Required Communications	RS-232 serial port

Please disable browser pop-up blockers for documents on cweldtech.com to allow PDF files.

Note - All documents are in an Adobe PDF file format.

Weld Monitoring Products

Weld Controlling Products

Support Products